Disables IP ARP to refresh its IP ARP entries before timing out.
| vr_name | Specifies a VR or VRF. |
Enabled.
The purpose of disabling ARP refresh is to reduce ARP traffic in a high node count Layer 2 switching only environment.
If you do not specify a VR or VRF, the command applies to the current VR context.
The following example disables IP ARP refresh:
disable iparp refresh
This command was first available in ExtremeXOS 10.1.
The vr option was added in ExtremeXOS 11.0.
This command is available on all Universal switches supported in this document.